The new Fuel EX Gen 6 is no Remedy, and I'm a fool for thinking it would be.įeeler: Considering selling the RS Super Delux Ultimate off my new Offering. Just trying to gauge whether or not the remote is a goner or if it can actually be saved.īest spade / shovel for slapping/shaping dirt Insert the brass fitting into the plastic tube. Epic RockShox Reverb/xLoc Bleed Kit - 2. SRAM has no technical documents that I can find for disassembling the remotes themselves, and this thing wont budge at all. I cannot figure out how to remove the old banjo fitting and install the new one. Assemble two RockShox Speed Lube Kit syringes: Install an o-ring onto the end of the brass fitting. Just wondering if anybody else has ever encountered a similar situation, and if there was a solution. Upgrade from crown adjust to remote adjust Includes two bleed syringes, torx wrench, Motion Control XDNA compression damper, XLoc remote lever and hose. It includes all the essentials to get the job done. and still haven't seen those parts come in.īut even without the kit on hand, I am having a hard time finding any way to get this remote apart. Upgrade your XLoc Full Sprint Remote from the crown adjust to remote adjust with this kit from RockShox. Compatibility: RockShox Monarch XX Manufacturer number: 11.4318.000.010 Assembly: handlebar, right over Matchmaker X-clamp Color: Black Weight: 74. A full flush of old fluid and bleeding the system yielded no desirable results, so I contacted both Cannondale and SRAM.Ĭannondale's (because its a lefty) answer was along the lines of "oh geez, I dunno, never seen it that bad before" and SRAM suggested that I rebuild the remote, and so I ordered a rebuild kit. Initially I suggested a bleed of the remote, as this is usually how I would go about solving the issue on the regular Xloc remotes, as well as reverb remotes. I have a customer's bike in, running the full sprint remote, but the remote is stuck in its depressed state. Reverb fluid is included SRAM Bleeding Edge Tool - Please note that Reverbs with the under bar lever also require the bleeding edge tool to perform the bleed. As a mechanic this is a first for me, wondering if anybody else has encountered a similar issue and if so how they resolved it. This is the kit needed to bleed RockShox hydraulic dropper post remotes including Reverb (w/plunger remote) and X-Loc (or RockShox suspension forks which use the same X-Loc style remote).
0 Comments
Leave a Reply. |